Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles Groups Groups
Filter by: Last 24 Hours Clear All
  • Davezj's Avatar
    Today, 09:41 PM
    Have you disconnected the cable from the sensor on the top of the gear box. the last car i looked at with the same issue had completely corroded terminals on the out put shaft sensor and they just turned to green dust when the cable was disconnected. the issue was a verted bonnet and the water draind collects in the output shaft speed sensor divot in the top of the gearbox. the moral of this story is don't use a vented bonnet in the rain. You can get water collecting in the divot for...
    1 replies | 14 view(s)
  • LegnumPower's Avatar
    Today, 04:17 PM
    My speedo sometimes stops working completely, or the speed starts rising with the revs, and then the gearbox goes into limp mode. I fiddled around a bit with the cable going to the gearbox output sensor, and it worked for a while, but after hitting a bump the poblem comes back. I'm thinking the problem is in the cable or connector of the output sensor, but are there any other obvious places where the fault might be?
    1 replies | 14 view(s)
  • shahzaib48's Avatar
    Today, 06:23 AM
    shahzaib48 replied to a thread new member in Newbies Area
    Welcome here
    9 replies | 944 view(s)
No More Results