4 to 5 stud conversion

[Gly]

any one done this??
i would like to do it to my 25ST (4WD),
its a prefacelift model..
i would like to change to 5 stud post facelift hubs/breaks etc...
(better selection in lager wheels + bigger breaks if i wanna change to evo brembos)

what bits would i need to make this a direct bolt off bolt on conversion??
would the driveshafts/cv's be a direct swap/fit??

[You See]

Can't you get adapter plates??

[Gly]

nope not 4 to 5 stud plates only ones that change the pdc.
planning on putting maybe 19" or 20" wheels on..
would like bigger breaks coz of these..

do it once and do it right...

this legnum will be all show when its done.

[richy rich]

i think you will have to change the hubs for the wheels.
hub carriers & wheel sensers to go to brembos

[marmel31]

this legnum will be all show when its done.

Pity it's missing a couple of turbo's :leer: /yes

[Wouter]

I think the quickest way to change the stud patern is to sell the car and buy a VR4. Less hassle and more fun!!! /Steeringw

[Kieran]

You have a 2.5ST 4WD that's only gotg 4 studs? I thought *all* 4WD Galants/Legnums were 5 stud? :inquisiti :inquisiti

[Kenneth]

I thought *all* 4WD Galants/Legnums were 5 stud? :inquisiti :inquisiti

Nope, my 1.8 4WD Galant was 4 stud... pity cause the wheels were actually reasonably good on it.

[bradc]

I actually thought all 4wd ones were 5 as well.

To be honest Gly, why don't you get a VR-4? I'm only 21, and insurance does allow it ;)

[Gly]

ive had many speeding tickets,
lost my licence for a year,
and i wrote off my last car, in an accedent which was my fault :(

[You See]

and i wrote off my last car, in an accedent which was my fault :(
Think about it this way, if you were going faster you may of avoided the accident...haha /yes

[richy rich]

Think about it this way, if you were going faster you may of avoided the accident...haha /yes
my last accident (not my fault) if i was going the speed i was going 5mins earlier i would not of been there but on the other hand if i hit at that speed id be dead........