Uniden Alarm Remote - Help Reprogramming

[Gly]

so my misses has a uniden alarm installed in her car...
not sure what modle as it was installed before we bought the car,

recently she managed to soak one of the remotes,
so we opened it up and let it dry...

how ever i think the water caused it to loose its programming,
as it still blinks when buttons are pushed but it wont opperate the alarm.

doz anyone know what has to be done to reprogram it??

Thanks

[Springie]

Give this a try:

CODE LEARNING
The alarm can learn a maximum of 4 remotes. RF CodeWash™ deletes all previous remotes when any
new remote is learned. This prevents unauthorized use of lost or stolen transmitters, and alerts the user if
someone has secretly code- learned a new transmitter. However, it also means that, when code-learning
is being done, ALL THE USER'S TRANSMITTERS MUST BE CODE LEARNED AT THE SAME TIME.
A. Procedure:
(1) Disarm the alarm.
(2) Turn the ignition switch ON/OFF 4 times within 15 seconds.
(3) Within 15 seconds, hold the first transmitter, and then push buttons #1 and #2 together until 1 chirp
confirms the code is learned (approximately 4 seconds), and that all previous transmitter codes
have been deleted. If no button is pressed within this 15-second period, code learning is exited,
and the old codes are retained.
(4) Within 15 seconds, push button #1 and #2 of the second transmitter (if available) together for at
least three seconds. One chirp confirms learned.
(5) Repeat step (4) until a maximum of 4 transmitters are learned. The siren chirps once for each
transmitter when its code is successfully learned.
B. Exit the code learning procedure — The alarm chirps the siren three times, exits the code learning
mode, and is disarmed if you learn the fourth transmitter's code, or if you turn the ignition switch ON, or
if you do nothing for 15 seconds.