View Full Version : VR4 Oil Cooler
Wodjno
18-02-2006, 08:11 PM
What size is the Oil Cooler on the VR4 ? ( Height, Width, Depth, Rows):inquisiti
And what would be an ideal upgrade size :thinking:
Same question also about the Trans Cooler :2thumbsup
WODJ
richy rich
18-02-2006, 08:15 PM
not 100% but isn't it one pipe that runs in front of the rad or am i thinking of the lancer.
Wodjno
18-02-2006, 08:17 PM
not 100% but isn't it one pipe that runs in front of the rad or am i thinking of the lancer.
There is 1 pipe that runs infront of the Rad. But not sure if thats the Trans Cooler ./help
richy rich
18-02-2006, 08:22 PM
ill look for you tomorrow i think you might be right.
richy rich
18-02-2006, 08:30 PM
just looked at my manual
it shows an oil cooler on the sohc
but non on the mivec
Wodjno
18-02-2006, 09:16 PM
I don't have a Mivec or a SOHC :thinking:
richy rich
18-02-2006, 09:21 PM
ok just trying to help
Wodjno
18-02-2006, 09:45 PM
Nor do you /pan :happy:
You sure you not looking at an FTO Book. /Hmmm
richy rich
18-02-2006, 09:48 PM
im looking at my 6a13 manual
is the mivec not the same as the quod cam we have
Wodjno
18-02-2006, 10:12 PM
I thought the MIVEC Head was fitted to certain FTO's and also the 2.4l .. Maybe the 2.0l v6 in the 7g to :inquisiti
richy rich
18-02-2006, 10:13 PM
feck knows
Wodjno
18-02-2006, 10:20 PM
/haz You still wanna open that Garage :2thumbsup
zedy1
18-02-2006, 10:33 PM
engine oil cooler on the oil filter housing (poss)
trans oil cooler under rad
power steering oil cooler in front of intercooler
well the trans cooler i have fitted is (after market)
280mm x 150mm x 19mm, and has 17 rows,
you will need a cooler with 8mm fittings
richy rich
18-02-2006, 10:41 PM
/haz You still wanna open that Garage :2thumbsup
yes/help
Kieran
18-02-2006, 10:56 PM
engine oil cooler on the oil filter housing (poss)
trans oil cooler under rad
power steering oil cooler in front of intercooler
Yep - I haven't seen a 8G VR-4 with a factory engine oil cooler - just the transmission cooler (or should that be heater/pan ) and the power steering cooler tubes.
richy rich
18-02-2006, 11:05 PM
so im right then we dont have one:2thumbsup
Wodjno
18-02-2006, 11:14 PM
so im right then we dont have one:2thumbsup
Yes your right .. :2thumbsup We don't have a MIVEC :party3:
richy rich
18-02-2006, 11:15 PM
/haz
valmes
19-02-2006, 04:38 AM
There is no STOCK oil cooler on our cars. You can install Greddy oil cooler (there are two types - 10 or 13 rows) it comes with oil filter relocation parts and also allows for oil temp. and pressure sensors to be installed (i've seen a thread about sandwich plates... ;) ). For those who decided to upgrade their turbos - oil line is kinda in the way, so might be a good idea to get this Oil cooler.
http://i9.photobucket.com/albums/a82/valmes/greddyoil.jpg
Trans cooler also is not existent in stock form... transmition is cooled via stock radiator (look at the lower part - you will see a line that goes in and out... in my case it's cut - I have a manual VR4 with radiator from an auto).
power steering - little aluminum tube that sits in front of stock intercooler (or behind it for me).
Wodjno
19-02-2006, 11:34 PM
Thanx all for your input. I have some idea of what to start looking for now :2thumbsup
Sports GT
20-02-2006, 01:53 PM
Don't these cars have water cooled oil coolers?
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.