PDA

View Full Version : Galant VR4 stud pattern?


Ultra VR-4
05-10-2003, 11:44 PM
Was just wondering what the stud pattern was for the Mitsubishi Galant VR4?

eg: are they 5x100, 5x114...etc
wildfaye
06-10-2003, 11:34 AM
5x114.3

cheers
Spirit
06-10-2003, 06:39 PM
Originally posted by wildfaye
5x114.3

cheers

spot on.....also centre bore is 67.1mm if required
Ultra VR-4
06-10-2003, 08:48 PM
so does that mean i can only have mags that are 5x114.3?
Spirit
06-10-2003, 09:22 PM
Yes mate, but I believe there are some multi stud pattern wheels out there too
calum
06-10-2003, 09:25 PM
No - you can use spacer/ pcd convertors. Make sure you take these into account when choosing the offset of your wheels, though - you'll have to get wheels with a greater positive offset INSERT INTO post VALUES (by the same amount as the thickness of the spacer. If standard offset is +38, then you adda 10mm spacer, you need to get a +48mm offset wheel to keep the alignment correct.

Calum