SNWMAD
12-07-2006, 05:18 AM
Well after using duct tape for months i finally had enough and took to my bumper with a hack saw. Then after that design looked terrible, i took it to a panel beater who cut it with his air saw and tidied things up to my design for free. I still have a little work to do on it but the results came out good considering that it cost me only some spray paint and some primmer to do.
Heres a pic of it as is:
http://www.clubvr4.com/forum/attachment.php?attachmentid=11774&stc=1&d=1152677583
I' don't know if that came out. It is a bad picture in rainy hamilton but you get the idea. This would only work if you ahd a front mount tho. Also my car is now on the lowest settings on the bilstein adjustables and this design scraps a hell of a lot less the with the middle piece in.
Anyhow, just thought i'd put this in to show that you don't have to fork out $500 plus dollar to get a new bumper if yours breaks, which is a common thing with these car esp that middle insert.
Heres a pic of it as is:
http://www.clubvr4.com/forum/attachment.php?attachmentid=11774&stc=1&d=1152677583
I' don't know if that came out. It is a bad picture in rainy hamilton but you get the idea. This would only work if you ahd a front mount tho. Also my car is now on the lowest settings on the bilstein adjustables and this design scraps a hell of a lot less the with the middle piece in.
Anyhow, just thought i'd put this in to show that you don't have to fork out $500 plus dollar to get a new bumper if yours breaks, which is a common thing with these car esp that middle insert.