Kenneth
21-12-2006, 04:16 AM
I am currently looking at pricing up the material for making stainless steel exhausts.
At this point the main thing holding me back is the lack of a TIG welder.
However, once sorted ill be looking at doing bits and pieces of exhausts.
First off I will be making the section from Cat to back axle. This requires 2 flanges, 2 resonators and some stainless tube.
if people are interested I can look at doing multiple units. This of course would spread the cost for some things and of course make it easier for me to get the stuff for initial startup (exhaust flanges laser cut, pipe in the 6M length needed to get it at a good rate and TIG welder)
so if you are interested let me know and i'll start pricing stuff up. Be aware that the actual building my not start for a couple of months depending on how quickly I can get stuff together.
At this point the main thing holding me back is the lack of a TIG welder.
However, once sorted ill be looking at doing bits and pieces of exhausts.
First off I will be making the section from Cat to back axle. This requires 2 flanges, 2 resonators and some stainless tube.
if people are interested I can look at doing multiple units. This of course would spread the cost for some things and of course make it easier for me to get the stuff for initial startup (exhaust flanges laser cut, pipe in the 6M length needed to get it at a good rate and TIG welder)
so if you are interested let me know and i'll start pricing stuff up. Be aware that the actual building my not start for a couple of months depending on how quickly I can get stuff together.