View Full Version : Bleeding the AYC hydraulic system - Article now available in the members area!
Kieran
27-04-2007, 01:24 AM
Thanks to the feedback from Wodjno & Louis in particular, coupled with my own discovery of the Mitsubishi EVO service manual and the recommended procedure for bleeding the AYC, I have now done this successfully too.
I have written an article on the procedure - available in the Article Library
Library main link:
http://www.clubvr4.com/forum/forumdisplay.php?f=135
Direct link to the AYC article:
http://www.clubvr4.com/forum/showthread.php?t=23948
richy rich
27-04-2007, 07:52 AM
Good write up k
just a couple of things i do different but not necessary.
1 take the road wheels off and use the nuts to re secure discs for safety reasons.(more stable, no rotational forces from wheels)
2 use a tie rap around throttle cable and the front brace bar to get 1000/2000 rpm(also can be a 1 man job but i would advise some one with you for safety reasons)
3 turn t/c off
4 put in to tip and select 3rd (just so you get no gear changes)
5 i use more than 1l off atf to make sure it is flushed nice and clean (on average 3l)
Kieran
27-04-2007, 11:01 AM
Oh yeah, I had to do step 3 as well. I'll add that to the guide.
I will need to do mine again next service as I don't think I got all the crappy fluid out - but it's certainly better than it was!
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.