PDA

View Full Version : Boost Controller Fitting



Little Miss Road Rage
03-06-2007, 08:51 AM
I have been looking for some info on this for so long my eyes have dried out and now hurt. I found a very useful link but the page was not there when I looked :( .

We have decided that as our skyline hasn't sold we might as well take the boost controller out of it and make use of it in our Leggie. A friend of ours is going to fit it and asked if there was any info on here that would help. So does anyone have any info?

Thanks
Kelly

Wodjno
03-06-2007, 10:38 AM
What Boost Controller is it ?

Little Miss Road Rage
03-06-2007, 11:35 AM
apexi colour i

Little Miss Road Rage
14-06-2007, 03:18 PM
Its a blitz sbc colour

Spirit
14-06-2007, 04:58 PM
Have replied to your PM Kelly

Goku
14-06-2007, 11:22 PM
I would like to know where you would put them on the later VR-4's aswell....

We have sold a few manual GFB ones and I'm not 100% sure on where to place them. On my one it's simple enough, but the later ones are slightly different.

Nutter_John
14-06-2007, 11:23 PM
Within the members area there are fitting instructions , they mostly fit in the same place .

Goku
15-06-2007, 12:41 AM
Hmmm.... when $$ allows I shall have to invest in the membership