peter thomson
07-07-2007, 07:31 PM
Hi i installed an SAFC2 today but i can't get it to initialise properly. I think it keeps returning to the hotwire setting rather than accepting karman input as when I start the engine the check engine light and TCL warnings light are flashing.
When I check the settings again it has gone back to hotwire. Am I initialising it incorrectly. I go to yes on the menu press the button and then turn off the ignition. Any advice from anybody who has fitted one.
Do I need to put in any of the warning data points at the moment or leave them until it has been set up on a rolling road.
When I check the settings again it has gone back to hotwire. Am I initialising it incorrectly. I go to yes on the menu press the button and then turn off the ignition. Any advice from anybody who has fitted one.
Do I need to put in any of the warning data points at the moment or leave them until it has been set up on a rolling road.