Mark 4
04-08-2007, 07:51 PM
Hi all, have a question which no doubt one of you helpful souls can answer.
I'm fitting my Emanage ultimate (slowly and carefully). I have got to the vehicle speed connection. It is plug 4, pin 16, or 86 if all the pins are numbered consecutively, white wire with green stripe.
Mine has been cut and the feed from the ecu is fed up under the dashboard. I assume that ralliart did thi when they did the original conversion on the car when it was new. (my speedo only shows mph, no km's)
Question is, should I simply tap into this circuit or is there somethin else that I need to do ?
Thanks in advance.
I'm fitting my Emanage ultimate (slowly and carefully). I have got to the vehicle speed connection. It is plug 4, pin 16, or 86 if all the pins are numbered consecutively, white wire with green stripe.
Mine has been cut and the feed from the ecu is fed up under the dashboard. I assume that ralliart did thi when they did the original conversion on the car when it was new. (my speedo only shows mph, no km's)
Question is, should I simply tap into this circuit or is there somethin else that I need to do ?
Thanks in advance.