Brembo vented disc

[jpnvr4]

Can these fit a VR4? ... I found them and they're 4 a galant so it should be somewhat close ... hoping so ... then I could put them on my preface... but I need a pros help, so... Kieran, gly, spirit, nick mann... U guys are pros in my eyes so I look for ur thoughts... and also do regular galant pads work on VR$'s .... or am I lookin for some more?

[Gly]

do they say if there for a vr4 galant?? they need to be 294mm diameter, and 5 x 114 stud pattern.

you can use evo4 disks if brembo have a specific one for them,

unsure if they normal galant pads will work sorry,
but as above evo4 pads work.

[jpnvr4]

My mistake guys ... I totally 4got 2 put up the link so U can see them ../pan :stupid: sorry ....
but here's the link
www.thepartsbin.com/sitemap/mitsubishi~brake_disc~parts.html

[ianturbo]

i think they are too small 276mm , you need 294mm or there abouts .
Ian
P.S whats it like havin Christmas in the hot sunshine ??:inquisiti

[Nick Mann]

See this thread for a catalogue that shows the standard disc sizes.

http://www.clubvr4.com/forum/showthread.php?t=15730

[jpnvr4]

P.S whats it like havin Christmas in the hot sunshine ??:inquisiti

not 2 bad .... but I miss the snow
/Hissy

[bradc]

wasn't 276mm the standard size for earlier VR-4's? (but obviously 4 stud)

Just keep an eye out for anything that says evo 4.

[jpnvr4]

ok so I'm stuck ... again..... I need rotors like yesterday .... my girlfriend took the car out and managed 2 rub the front pads rite down 2 the metel .... I now have 2 front rotors that need shaving and or replacing ... so I need help .. preface galant.... I could do with an upgrade but I guess I need hubs off a facelift 4 any chance of that.... but I could still use the help...

[Goku]

Get DBA Discs, they will fit your car

http://www.dba.com.au/2006/default.asp

there is a listing in there for the front rotors for the 8G VR-4