View Full Version : Denso 460cc fuel injectors
Six Denso top feed low impedance 460cc fuel injectors. Cleaned and flow matched, £140 delivered, email o_rion_@hotmail.com.
pjjohnson
03-02-2004, 05:15 PM
Maybe interested - have these been used on a VR4 ?
enigma
03-02-2004, 05:57 PM
Sounds interesting! Did you run with an uprated pump also?
SGHOM
03-02-2004, 06:00 PM
same post 9 months ago ?? £15 cheaper ??
I have one more set. Yes an uprated pump is recommended. These fit VR4 and are low impedance, square plug, centre notch, just like stock connector.
pjjohnson
05-02-2004, 07:01 PM
I'll have them
enigma
05-02-2004, 07:05 PM
Cool! What sort of power levels are you wanting?
pjjohnson
05-02-2004, 07:18 PM
As much as possible, without gas !
I'm not going to put them on yet, just have a feeling in the future that I may need some.
If not then somebody, somewhere may take them off my hands.
enigma
05-02-2004, 07:21 PM
Have you any idea what sort of duty cycle your injectors are running at the moment? My boost controller will tell me if I rewire it, just haven't got round to it!
Have you raised the fuel pressure? I was toying with the idea of increasing it a couple of psi and getting an APEXi SAFC II
pjjohnson
05-02-2004, 07:27 PM
Don't know about the duty cycle.
In theory I think I may have raised fuel pressure with a bigger fuel pump and fuel pressure regulator, but haven't got any figures.
zedy1
05-02-2004, 11:43 PM
a couple of psi and getting an APEXi SAFC II[/QUOTE]
dave i was looing at getting the apexi safc, do you think ill still need the hks fcd m8
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.