View Full Version : removing torque convertor
Hi, can anyone tell me how i remove the torque convertor from the engine, i managed to get the gearbox off but cant fiqure out how remove the torque convertor
any help would be much appreciated
Nick Mann
02-02-2008, 11:29 PM
It is held to the flywheel with four bolts. You need to remove the inspection plate at the bottom of the bellhousing, and then rotate the crank to remove each bolt in turn.
Hope that helps!
There is a very good "How To" article in the members section. With pictures! One of the merits of full membership......
Good luck, either way!
thanks for that, the engine was sitting on the ground so couldnt see the inspection plate >_<
cheers
u've got to raise the engine to a workable height for u to loose those 4 bolts
be careful, DON't let the engine fall on u or your hands while u are working
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.