HMG1K
25-08-2008, 06:55 PM
As above says, this is a two year old, in fully working order, Kenwood KSC-WA82RC Active Bass Tube complete with remote and cables, in mint condition.
This is a fab system producing deep bass as it uses a tube type speaker enclosure while the large concave centre cap effectively eliminates distortion.
On the rear panel there are parallel fins that improve heat dissipation of the built-in amplifier, while the Kenwood triangle LED lends an attractive aspect to the rear view.
The remote control unit can be detached from the speaker unit and operated via a 6.0m shielded cable
** 200mm blue-coated paper cone woofer
** Remote controllable variable input sensitivity (gain)
** Remote controllable variable low-pass filter (cut-off frequencies: 60, 80, 120, 160Hz)
** Remote controllable phase reverse switch
** Accepts speaker level inputs if required
** Gold-plated RCA type input connectors
** Supplied with mounting belt
** Overall approx. dimensions 265W x 265H x 470L (mm)
Peak Power
100W + 100W
Freq response
20Hz-1kHz
Magnet Weight
568g
As I say, all th cables and remote come with it - all you'll need is your own length of yellow battery cable to your desired length with a 30A fuse inline. This, with a bullet connector on one end will connect to the existing loom.
I've just upgrated mine to a smaller Kenwood sub, the Kenwood KSC-SW10.
Selling for £100 - collection from west London (Ealing) prefered as this is a heavy beast - otherwise I can do Royal Mail ParcelForce, which is around £20.
This is a fab system producing deep bass as it uses a tube type speaker enclosure while the large concave centre cap effectively eliminates distortion.
On the rear panel there are parallel fins that improve heat dissipation of the built-in amplifier, while the Kenwood triangle LED lends an attractive aspect to the rear view.
The remote control unit can be detached from the speaker unit and operated via a 6.0m shielded cable
** 200mm blue-coated paper cone woofer
** Remote controllable variable input sensitivity (gain)
** Remote controllable variable low-pass filter (cut-off frequencies: 60, 80, 120, 160Hz)
** Remote controllable phase reverse switch
** Accepts speaker level inputs if required
** Gold-plated RCA type input connectors
** Supplied with mounting belt
** Overall approx. dimensions 265W x 265H x 470L (mm)
Peak Power
100W + 100W
Freq response
20Hz-1kHz
Magnet Weight
568g
As I say, all th cables and remote come with it - all you'll need is your own length of yellow battery cable to your desired length with a 30A fuse inline. This, with a bullet connector on one end will connect to the existing loom.
I've just upgrated mine to a smaller Kenwood sub, the Kenwood KSC-SW10.
Selling for £100 - collection from west London (Ealing) prefered as this is a heavy beast - otherwise I can do Royal Mail ParcelForce, which is around £20.