View Full Version : apexi avcr
psbarham
09-10-2008, 08:37 PM
does any one know if the MAP sensor on the apexi avcr boost controller has a 5 volt output from it so i can datalog from it?
Nutter_John
09-10-2008, 09:13 PM
The standard sensor has 3 wires , vref 5v , gnd and 0-5v source , what you need to do is tap the source and that will give you the boost as a voltage between 0-5v
thehedgepig
09-10-2008, 09:31 PM
The standard sensor has 3 wires , vref 5v , gnd and 0-5v source , what you need to do is tap the source and that will give you the boost as a voltage between 0-5v
Your just far to clever for your own good.... But you already know that don't you!!!
Nutter_John
09-10-2008, 09:32 PM
Yeah and I also knew you were going to say that :P
psbarham
09-10-2008, 09:40 PM
The standard sensor has 3 wires , vref 5v , gnd and 0-5v source , what you need to do is tap the source and that will give you the boost as a voltage between 0-5v
excellent mate, you've confirmed my thoughts.
Mark 4
09-10-2008, 09:41 PM
Your just far to clever for your own good.... But you already know that don't you!!!
I concur !
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.