Help ! Boost controller Blitz DSBC...

[horseman59]

Hello.

I am the new owner of Jack Daniels.
I have some problem to configure my boost controller. It is a Blitz boost controller, type DSBC.
Can you tell me what the "scramble" and how does it work?
I would like 1bar pressure continues. Outside I make a pique pressure to 1.15 bar and then I dropped quickly.But how to increase the time to boost? indeed visibly with a ratio of 70, I have a pique pressure at 1 bar, and then very quickly the pressure drops and stabilizes at 0.7 bar. Is this normal?
Use what values you?
Ratio?
Gain?
max pressure limits? and ratio?
scramble? P? C?

Thank you for your answers!

[Kieran]

These should help you Florent -

The exact settings to use depend on the car.... Each VR-4 will need slightly different settings to get the best result - No two cars are the same.

'Scramble' boost is a feature that allows you to go beyond your 'Normal' maximum for a brief period of time. Say you have Low boost set at 0.6 bar and High set at 0.9, well you could set 'Scramble' boost to 1.1 bar but only for a small time, say 30 seconds. It's used for when you just need that little bit extra.

These should help you set it up:

http://www.clubvr4.com/forum/showthread.php?t=20027

And there's a guide here too:
http://www.geocities.com/MotorCity/Speedway/9589/dsbc_manual.html

[horseman59]

Thank you very much Kieran ;)