View Full Version : hub ?
ianturbo
08-01-2009, 10:20 PM
Do i need to take the driveshaft out and all the hub assembley to fit hub and bearing or can i do it in situ ??? FRONT one(its a job for saturday and am thinking a few days in advance !!:thinking:
ian
peter thomson
08-01-2009, 10:25 PM
Have you read this article Ian
http://www.clubvr4.com/forum/showthread.php?t=22441&highlight=wheel
ianturbo
08-01-2009, 10:35 PM
Have you read this article Ian
http://www.clubvr4.com/forum/showthread.php?t=22441&highlight=wheel
Yep ,Well have now !!! cheers Peter !!
ian
peter thomson
08-01-2009, 10:39 PM
I'll be doing the same job in a week or so.
ianturbo
08-01-2009, 11:47 PM
i'll let you know how it goes !!:inquisiti
ian
Davezj
09-01-2009, 12:01 AM
if you haven't had yous off in a while then the hub carrier out method is the best way to go.
undo the bolt holding it on by about 5mm then go round hutting the back of the bolt in an X with a copper/leather hammer. if you haven't got one of those then some hardwood (softwood will just splinter) and a normal hammer.
ianturbo
09-01-2009, 12:09 AM
I have got a slide hammer to use , so will try that first :smash: :smash: :smash:
ian
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.