PDA

View Full Version : FS: wiring loom for the factory heated seats


GalantOnly
29-03-2009, 04:34 AM
For people, who replaced/will replace their original cloth seats with heated leather ones, but have nothing to connect them to...

Complete, with all wires, connectors, switch, mounting console and step-by-step "instruction manual" in which I explain how to do it ... Wires are OEM wires with OEM pins, right colour and right length - sort of plug-and-play in existing connectors... "All" you have to do is to strip some of car loom down and insert those wires into it - the result will be as good as factory made loom :scholar: (couple of hours job...)

£50...

PS: got the same kit for electric seats too, with wires and connectors...
Atik
29-03-2009, 10:31 AM
Noooo... after all the headache I went throught working out the controls for mine. /pan

Hehehe

Good luck with the sale. [I think Peter Thomson has leathers that are not yet wired up.]
GalantOnly
29-03-2009, 08:06 PM
Sold............
v6 galant
15-03-2013, 07:15 AM
Mm....
GalantOnly
15-03-2013, 07:33 AM
Jay, did you check if you already got those white connectors under the front seats? Many N/A V6 got "plug-and-play" loom for heated seats from factory
v6 galant
15-03-2013, 08:19 AM
I've got this under my front seat s


The clear plug next to the black one is live
v6 galant
15-03-2013, 08:33 AM
Have no switches or wires in center consol
GalantOnly
15-03-2013, 09:27 AM
The clear connector is the 12V constant power for electric seats, the white one is the feed for heating element from the switch. So you have at least half of the wiring needed. Take the center console off and look for the unused white connector somewhere between gear lever and hand brake. You may be lucky and only thing you'll need is the switch:)
v6 galant
15-03-2013, 09:28 AM
No it's not there
v6 galant
15-03-2013, 07:13 PM
I don't have any there so half
awkgah
15-03-2013, 07:47 PM
I had all the wiring except srs and heated switches. bought switches with holder for £20 and off we go. its on a 2.0 sport
legnum1
17-03-2013, 01:47 PM
Is it worth the effort if none of the connectors are present? I have a Legnum and have the offer of front/heated/electric seats. I can probably get the switches and some of the loom but am I wasting my time and possibly incurring a big bill?
Atik
17-03-2013, 02:08 PM
It wont cost you much at all if you are willing to tackle it yourself.

I just fit the circuits in my car for the heated/power seats and all in, just needed about 3m of cable, one relay, a few crimps and a few hours of time. I have the circuit diagram and even a guide somewhere on the forum, and it is well worth the investment.