Davezj
04-07-2009, 10:07 PM
does anyone have the pinout for the 3 connectors on the back of the control unit.
the bottom right and left are for the motors and i can get them later if necessary, but it is the center power connector i need for now.
there are 4 pins
perminent 12V.
accesory 12V.
illumination power (12v i think).
ground.
but i don't know which pin is which.
i have a controller and i want to power it up to check it works. before i go out a buy the motors the power harness and the motor extention harness for tein.
the bottom right and left are for the motors and i can get them later if necessary, but it is the center power connector i need for now.
there are 4 pins
perminent 12V.
accesory 12V.
illumination power (12v i think).
ground.
but i don't know which pin is which.
i have a controller and i want to power it up to check it works. before i go out a buy the motors the power harness and the motor extention harness for tein.