View Full Version : Changing VR-4 Cambelt
frankoni
03-02-2010, 10:09 PM
I've been reading the article about changing the cambelt on my VR-4 , can someone tell me where i can get the special tools needed to do it ??????
cheers
Frank
Nutter_John
03-02-2010, 10:12 PM
which special tools are you reffering to ?
camskill sell some tools for the evo which are the same
frankoni
03-02-2010, 10:16 PM
Cam locking tool and Timing idler adjusting tool !!
Nutter_John
03-02-2010, 10:20 PM
YOu only need to lock the rear bank and can make that yourself with two bits of metal and a bolt .
The tensioner tool is on the camskill website in the evo section around £36
frankoni
03-02-2010, 10:27 PM
I dont suppose youve got any pics of the locking tool ??
Nutter_John
03-02-2010, 10:29 PM
http://camskill.co.uk/products.php?plid=m8b0s2331p12861
I have one you can loan if you want ?
You dont need any special tools at all. Richie's article states the method for doing it without from memory.
Youve just got to put the rear bank 1 tooth out before tensioning, and as long as you have the new tensioner in the same position as the old, leaving the hydraulic one on 1 bolt you can lever it in place to tension.
Eurospec
04-02-2010, 06:35 PM
Its actually easier without the cam locks, but you can do it with if you prefer.
Cheers,
Ben.
elnevio
04-02-2010, 08:54 PM
Its actually easier without the cam locks, but you can do it with if you prefer.
Cheers,
Ben.
Top tip! :thumbsup: :eurospec:
Although not quite the same as the Top Tips sent in to Viz! :D
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.