Changing VR-4 Cambelt

[frankoni]

I've been reading the article about changing the cambelt on my VR-4 , can someone tell me where i can get the special tools needed to do it ??????

cheers
Frank

[Nutter_John]

which special tools are you reffering to ?

camskill sell some tools for the evo which are the same

[frankoni]

Cam locking tool and Timing idler adjusting tool !!

[Nutter_John]

YOu only need to lock the rear bank and can make that yourself with two bits of metal and a bolt .


The tensioner tool is on the camskill website in the evo section around £36

[frankoni]

I dont suppose youve got any pics of the locking tool ??

[Nutter_John]

http://camskill.co.uk/products.php?plid=m8b0s2331p12861

I have one you can loan if you want ?

[Gowf]

You dont need any special tools at all. Richie's article states the method for doing it without from memory.

Youve just got to put the rear bank 1 tooth out before tensioning, and as long as you have the new tensioner in the same position as the old, leaving the hydraulic one on 1 bolt you can lever it in place to tension.

[Eurospec]

Its actually easier without the cam locks, but you can do it with if you prefer.

Cheers,

Ben.

[elnevio]

Its actually easier without the cam locks, but you can do it with if you prefer.

Cheers,

Ben.
Top tip! :thumbsup: :eurospec:



Although not quite the same as the Top Tips sent in to Viz! :D