View Full Version : evo wheels
strangebat
25-07-2004, 10:13 PM
anyone know if alloys from an evo vii have the same pdc, offset etc as a legnum vr4(yes i'm watching those wheels on ebay) :-D
Spirit
25-07-2004, 11:35 PM
As far as I know they will go straight on mate - pcd is 114.3, offset +38 to +45, centre bore 67.1mm
strangebat
26-07-2004, 06:55 AM
cheers mate :thumbsup:
Nick Mann
26-07-2004, 07:59 AM
I'm almost certain that they go straight on. Some members have done it. I think the offset may be a few mm bigger - I also think that is a good thing!
Nick Mann
26-07-2004, 08:21 AM
THESE (http://www.lancerregister.com/showthread.php?s=&threadid=52377) are the type being worn by Simons car at the mo. Don't know if that interests you or not!
Roadrunner
26-07-2004, 11:40 AM
anyone know if alloys from an evo vii have the same pdc, offset etc as a legnum vr4(yes i'm watching those wheels on ebay) :-D
Yep, I have Evo VII wheels on my car (there used to be pictures on here somewhere but they seem to have disappeared ...). Wheels are 17"x8" with +38 offset, which makes the outer rim around 2cm further away from the hub than the standard wheel. With 235/45x17 tyres (standard on Evo VII), there's very slight fouling on the inside of the rear plastic arches with a full load in the car, but that's easily trimmed (or wait until the tyres do the trimming for you ;) ). Probably fine with 225 tyres (VR-4 standard).
Brian
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.