car ramps

[ANTHONY]

i need to fit my new exhaust tomorrow will i be able to back it up onto ramps without hitting the front spoiler (car not lowered)

[Nutter_John]

I don't think a vr4 will fit onto standard car ramps , but I may be wrong

[ANTHONY]

I don't think a vr4 will fit onto standard car ramps , but I may be wrongwhat reason john?

[Nick Mann]

Standard height VR4's will reverse on to my small ramps. The rear bumper *just* clears the lip on the back of the ramps. This only works if the car is starting on level ground, and the front bumper will still be a couple of inches or more of the ground.

Even lowered cars go quite a long way into the air at the back before the bumpers hit the ground at the front - My 3 ton Sealey trolley jack can't quite lift the back of VR4's high enough to get the front bumper to the floor - even when they are lowered!

[ANTHONY]

thanks Nick ,,,now for a dry day

[Wodjno]

I have standard car ramps and can reverse my VR4 onto them with no issues. The car is a Tad lower than standard. My 1st VR4 was much lower and just needed a helping hand with 2 nice strong pieces of timber to help them up onto the 1st rung.
Going forward onto the ramps with the present VR needs the timbers to stop catching on the front lip.

Sure thered a Pic on here recently of my VR reversed onto ramps showing my Zorst for PThompson /Hmmm

Cheers

Wodj

[Wodjno]

thanks Nick ,,,now for a dry day

Dry Day ?

Even if it's been raining it'll be dry underneath the car /yes

[Davezj]

yep i have standard car ramp standard ride hieght and it will back on to them no problems.
will not go on forward though.

[godzilla]

Mine is a fraction lower than stock and i have the Dolphin rear bar and it backs up onto my full size standard ramps piece of piss.

[ANTHONY]

yes it did fit and was a nice dry day Glen