View Full Version : 91 VR4 Main ECU computer
ceaborn
08-05-2010, 02:41 AM
Hello everyone! I am working on my 91 VR4 I just purchased and before I started taring things apart to find it's location, I thought I would ask.
Where is the ECM or ECU located on this VR4? there are control boxes everywhere!
Thank you
Kieran
08-05-2010, 10:13 AM
Welcome - Not often we see US 6G owners on here! :)
As I recall, the ECU is in the same location on the US models as it is on the Japanese ones - It's up the side of the glovebox, bolted to the bottom bit of the A-pillar. To get at it, drop the glovebox down and remove the stop so it drops all the way to the floor, remove the side trim and the lower kick/scuff trim (from memory a couple of crosshead screws, very obvious, nothing blind) and then you can wiggle your fingers in with a 10mm flexible-head ratchet spanner to get the bolts.
Hope that helps - and if you get stuck, you can try http://www.galantvr4.org/ubbthreads/ubbthreads.php - That's the stateside GVR4 owners club and is full of good stuff. :)
ceaborn
08-05-2010, 04:29 PM
Thank you very much, this will keep me from taring through the whole car.
Much Appreciated!
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.