part number for

[sightless]

gasket set for galant 97 rear spoiler.

Basically the foamy stuff between the spoiler and the boot.

[welshman010]

Subscribing to thread, I need this to.

[apeman69]

This any good to you?
GASKET, AIR SPOILER SIDE, LH - 70414L - PART NO. MR358303
GASKET, AIR SPOILER SIDE, RH - 70414R - PART NO. MR358304
GROMMET, AIR SPOILER - 70496 - PART NO. MB645307
BOLT, AIR SPOILER - 70499 - PART NO. MS240028

These are for a VR-4 made in 2000. If you want to PM me your chassis number(s) I can check if they're the same.

[Davezj]

personally i would just use some thin single sided foam tape if you find the proper stuff is too expensive.

i think the stuff i used to fit a friends spoiler on a Galoon was 3mm think. All you need is a couple of bits of tape one at the front and one at the back to space it correctly and stop any vibration/wobble.

here is a little info for you,
on the saloon you undo the bolts to remove the spoiler and then you kind of have to rip apart the front snap fixings (plastic ball and socket which just pulls apart), by pushing the back of the spoiler up.
Be careful with the rear brake light wire, when you rip the front fixing apart, when they pop apart it feels like you have just broken something.