before i break something else

[VR4Kaos]

before i break something else could someone be kind enought to give me a layman terms of how this Sard fuel reg is installed ie which pipe where please
thankyou in advance :iloveyou: /rally
36137

36138

[swinks]

Here Karl:
http://www.clubvr4.com/forum/showthread.php?t=22444

Use sometimes "search" option, please....:d

[VR457]

Have you sorted your boost problems out yet?

[PaddyB]

/pan I can see a little plume of black smoke rising from the horizon to the south ...

[andyleaves]

oh eck!!!
Guess will be down to what 1 super now then?
Only joking mate...

[Gowf]

One thing i forgot to ask you Karl, do you have a guage to set it up with?

[VR4Kaos]

One thing i forgot to ask you Karl, do you have a guage to set it up with?
errrrmmmm nope :curtain: got and air fuel ratio gauge tho

[Gowf]

thats not going to help. You need to set the fuel rail pressure to 3bar relative to atmospheric pressure. If you dont have a guage youl never know other than just by having hugely rich or lean, both being detrimental

[VR4Kaos]

whats the soloution gareth mate get one that has one one or can i get around that one ?

[VR4Kaos]

suppose i should hard wire my fuel pump while im @ it

[Gowf]

You dont really need one in the cabin so dont worry about that. I do have one that you could borrow to set it with, its pretty self explanitory so i could post it up to you and then you just send it back when done. I should be back home on monday at some point so can get it in the post tues.

Yes though, you should hardwire the pump. Its pretty simple, there is an article on it on here somewhere. I would say i'd just send mine up to you, but you still need to splice into your loom so it wouldnt really make much odds.

[Wodjno]

One thing i forgot to ask you Karl, do you have a guage to set it up with?

I may have a gauge or 2 kicking around from my group by FPR's. I'll take a look t'mora and see if i can find 1 and make it useable for Karl to set up his Sard ..

Wodj

[VR4Kaos]

thank you both very much much appretated

[Wodjno]

Karl..

Sorry for delay as i forgot /Help

This is a gauge from an FPR. I have afixed some fuel pipe to it and tested it upto 80psi /yes
You will need a T-Piece and some joiners and clamps to finish it off so u can fit it inline though.. If i had some here i woulda knocked it all up for ya /yes But i don't :(
Let me know if it's any good to ya or if your gonna wait for GOWF's ..

Heres a Pic of it tested at 60psi..
uploaded/450/1279212408.jpg



Cheers

Wodj

PS.. Makes u jump a little when summat pops off at 80psi :anxious:

[VR4Kaos]

Karl..

Sorry for delay as i forgot /Help

This is a gauge from an FPR. I have afixed some fuel pipe to it and tested it upto 80psi /yes
You will need a T-Piece and some joiners and clamps to finish it off so u can fit it inline though.. If i had some here i woulda knocked it all up for ya /yes But i don't :(
Let me know if it's any good to ya or if your gonna wait for GOWF's ..



Cheers

Wodj
how do mate that will be great you are a diamond i do have some tee's and clamps ect left over form when i did vac pipes pm me cost's mate thank you very much it is apprteiated so much
Karl :3d: