View Full Version : Hub Torque settings
richTvr4
04-08-2010, 05:42 PM
Hi Guys,
I am wondering if anybody can help me, I have just replaced my ABS rings on both rear shafts and one front shaft on my 2001 VR4 Gallant and am wondering what the correct torque is for the Hubs..?? (Big Nut) I looked on the Auto data CD and all I got was the settings for the V6-24V.
Cheers.:thumbsup:
GalantOnly
04-08-2010, 05:49 PM
200-250 Nm
Nick Mann
04-08-2010, 05:55 PM
:iagree:
Wodjno
04-08-2010, 05:56 PM
Or in Ingrish about 180 ft/lbs :p
GalantOnly
04-08-2010, 06:00 PM
Or in Ingrish about 180 ft/lbs :p
/boxing
richTvr4
04-08-2010, 06:59 PM
Perfect cheers guys,
Nutter_John
04-08-2010, 07:01 PM
Those will be dry setting so don't tighten them to that level if the thread has any lube on it
Wodjno
04-08-2010, 07:06 PM
Those will be dry setting so don't tighten them to that level if the thread has any lube on it
Is that dry clean ? Or dry rusted or corroded :thinking2
Nutter_John
04-08-2010, 07:07 PM
Dry clean of course , rusty and corroded is a special value :D
GalantOnly
04-08-2010, 07:17 PM
Outside temperature must be 21,6 degree, otherwise you must use special "cold" or "warm" torque values.../yes
Wodjno
04-08-2010, 07:20 PM
Outside temperature must be 21,6 degree, otherwise you must use special "cold" or "warm" torque values.../yes
Is that degrees C or Degrees F, Lubed, Dry, Coroded, Rusty? And is this at Sea level ? Or in a Vacuum ? /Hmmm
GalantOnly
04-08-2010, 08:11 PM
Is that degrees C or Degrees F, Lubed, Dry, Coroded, Rusty? And is this at Sea level ? Or in a Vacuum ? /Hmmm
:toilet: Sea level?! /haz
swinks
04-08-2010, 10:28 PM
...and external diameter of triceps brachii muscle :joker:
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.