Hub Torque settings

[richTvr4]

Hi Guys,

I am wondering if anybody can help me, I have just replaced my ABS rings on both rear shafts and one front shaft on my 2001 VR4 Gallant and am wondering what the correct torque is for the Hubs..?? (Big Nut) I looked on the Auto data CD and all I got was the settings for the V6-24V.

Cheers.:thumbsup:

[GalantOnly]

200-250 Nm

[Nick Mann]

:iagree:

[Wodjno]

Or in Ingrish about 180 ft/lbs :p

[GalantOnly]

Or in Ingrish about 180 ft/lbs :p

/boxing

[richTvr4]

Perfect cheers guys,

[Nutter_John]

Those will be dry setting so don't tighten them to that level if the thread has any lube on it

[Wodjno]

Those will be dry setting so don't tighten them to that level if the thread has any lube on it

Is that dry clean ? Or dry rusted or corroded :thinking2

[Nutter_John]

Dry clean of course , rusty and corroded is a special value :D

[GalantOnly]

Outside temperature must be 21,6 degree, otherwise you must use special "cold" or "warm" torque values.../yes

[Wodjno]

Outside temperature must be 21,6 degree, otherwise you must use special "cold" or "warm" torque values.../yes

Is that degrees C or Degrees F, Lubed, Dry, Coroded, Rusty? And is this at Sea level ? Or in a Vacuum ? /Hmmm

[GalantOnly]

Is that degrees C or Degrees F, Lubed, Dry, Coroded, Rusty? And is this at Sea level ? Or in a Vacuum ? /Hmmm

:toilet: Sea level?! /haz

[swinks]

...and external diameter of triceps brachii muscle :joker: