View Full Version : Torque setting for top engine mount?
deacolanza
15-08-2010, 09:09 AM
Hi can someone tell me the torque settings for a top engine mount?
Subaru ETA
15-08-2010, 09:20 AM
Tight
scott.mohekey
15-08-2010, 10:16 AM
Tight
That's exactly what I came into this thread to say! /pan
Wodjno
15-08-2010, 10:37 AM
Which 1's exactly ?
bradc
16-08-2010, 08:19 PM
I'm guessing the ones near the suspension shock towers.
The correct answer is until you get it up to tight, then a couple of grunts of tightness ;)
Wodjno
16-08-2010, 08:39 PM
I'm guessing the ones near the suspension shock towers.
The correct answer is until you get it up to tight, then a couple of grunts of tightness ;)
But there 17's on the Gearbox mount and 14's on the engine ? Think thats the right way round ? each require different torque.
deacolanza
16-08-2010, 08:59 PM
I just put in a new top engine mount on the drivers side and I have done it up tight. Just wondering if there was a torque setting for it, but I guess doing it up tight will do it thanks for your help.
Wodjno
16-08-2010, 09:26 PM
I just put in a new top engine mount on the drivers side and I have done it up tight. Just wondering if there was a torque setting for it, but I guess doing it up tight will do it thanks for your help.
The bolt is 67Nm
Nut is 57Nm
Horizontal bolt is 98 -118Nm( this is with full engine weight applied /yes )
deacolanza
17-08-2010, 05:07 AM
The bolt is 67Nm
Nut is 57Nm
Horizontal bolt is 98 -118Nm( this is with full engine weight applied /yes )
You are truely the master. :2thumbsup
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.