Mitsubishi Triple DIN Evo gauge install

[VR457]

Finally got these sorted and working! The gauges are 45mm in size, standard gauges being 52mm.

Positioning could be better, i can't see the top section of the boost gauge from the drivers side but since it's set, i don't really need to see it that clearly; just enough to know that it's just past the 12 o clock position - ie 0.8 bar.

The gauges have been mounted onto mdf sprayed black with some plastic bits cut out where the clock sits.

38394

38395

[ANTHONY]

sorry but looks odd to me, would have been better under the radio

[Atik]

Looks tidy but odd with the middle one higher than the others. I think they should be aligned horizontally to make it look totally clean. But good job.

[gee118]

The guages look to be in the perfect places for reading to me. I like the fact that you can just glance over without having to look down to where your double DIN radio should be.
Nice job, and discreet too!
Would have been funny if you had put a clock in :)

[Atik]

Hah, an analogue clock, like the Mondeo /lol

[VR457]

It doesn't look too bad in the flesh. Plus it is very discreet.

If i get round to redoing it i will try and make it flush. As you can see from the pictures the lower readings from the boost gauge will be lost. The other two could rise up a bit so as to make the Mitsi logo more visible.