View Full Version : O-Ring for the Turbo/piping
NLduffyNL
29-01-2011, 03:21 AM
You got on each end of the Y-piece and O-ring (that fits into the Turbo's)
I want 2 new ones.
Because 1 is damaged a bit and its leaking a lot of pressure there.
can someone tell me where i can get those?
(ive searched on camskill and on the forum but i couldnt find it... hope im not blind/to tired because of the time ;) )
Cheers, Mark
elnevio
29-01-2011, 10:02 AM
Part number is MD070507. Best speak to Mitsubishi! Not a normal part that needs replacing, so I don't think there has been much demand for them.
41067
naughtika
29-01-2011, 12:43 PM
replaced mine with a silicon based o-ring, was supplied by an o-ring specialist shop.. only cost me $10 for 4
best to bring in your old one.. and might be good to go a little bit over sized with it too..
NLduffyNL
29-01-2011, 05:30 PM
Uhmm i might concider both choices.
Today been at the dealer to ask how long 2 original ones will take to get here and what i will cost.
And if its taking to long or its to expensive i'll go try and find a shop that can deliver me my O-ring i need.
Thank you both for your reaction
Mark 4
29-01-2011, 06:23 PM
Post one to polymax.co.uk, they will sort it for you.
Ask for James.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.