MYKEY
06-02-2011, 10:16 PM
Seeking advice :smart:
looking at fitting a hi-vis dash that i acquired a while back into my type v, as far as i can make out from reading through posts i need to bridge a wiring path from from pins 4 and 5 and make a cut somewhere but not to sure where :undecided
http://i942.photobucket.com/albums/ad270/galant1569/VR4/modyfikacjazegarwhcjpgzj71.jpg
I do not have a surround with the dimmer on it for the dash, would this also be a problem, not bothered about dimming as long as its illuminated.
Any advice much appreciated
Cheers
Mike :)
looking at fitting a hi-vis dash that i acquired a while back into my type v, as far as i can make out from reading through posts i need to bridge a wiring path from from pins 4 and 5 and make a cut somewhere but not to sure where :undecided
http://i942.photobucket.com/albums/ad270/galant1569/VR4/modyfikacjazegarwhcjpgzj71.jpg
I do not have a surround with the dimmer on it for the dash, would this also be a problem, not bothered about dimming as long as its illuminated.
Any advice much appreciated
Cheers
Mike :)