hard piping info

[Oggie]

well may as well make this nice and simple.

alli have left my my engine bay to complete my hard piping it replace the soft piping.
Can anyone give me the measurements and angles i need to replace them?
also piping sizes too "ie" 2 inch or 2.5 ich etc.

prefer to also replace the last hard pipe/plastic pipe on the inlet manifold as well if possible at all.

any help would be bloody greatful.

[aboo]

http://www.clubvr4.com/forum/showthread.php?45945-Custom-made-hard-piping-how-to...

[Oggie]

hmmm i did a search and i musta sucked at searchign coz i didnt find it..

aboo you are the wind beneath my wings /bananaroc

[Fully]

http://www.trademe.co.nz/stores/scarles-performance-car-parts

Go have a chat to Andrew, im sure he will sort you out.

http://www.trademe.co.nz/motors/car-parts-accessories/performance/turbos/auction-380827129.htm

[Oggie]

http://www.trademe.co.nz/stores/scarles-performance-car-parts

Go have a chat to Andrew, im sure he will sort you out.

http://www.trademe.co.nz/motors/car-parts-accessories/performance/turbos/auction-380827129.htm

tyvm shane, was at repco today speaking to one of the lads. and its 50 bucks for a 300mm pipe of 2 inches. i guess repco does mean Rip Every Poor **** Off

[Fully]

Your welcome mate =)

I have no idea who else is in the Auckland area. I have had very good service with scarles.
Shop around You could try Steel and Tube also.

[CANDEE]

You can try Road & Track as well. :) Kev is a good guy, has access to a lot of stuff that he doesnt stock, and if he cant get it, he will point you in the right direction. :)

They also have Flextech silicon joiners too.

[swinks]

Check out this thread:
http://www.clubvr4.com/forum/showthread.php?50728-Hard-pipe-kit-DIY-guide&p=567473#post567473