Rear Wheel Bearing

[thedark1]

Where can I find a Rear wheel bearing for my PFL 98 Legnum (I understand they are the same facelift vs non facelift?)

Mitsi Wants $510 + GST just for the bearing and 400 to fit it. Surely that's far too much for one wheel bearing?

On a random note, would now be a good time to get a FL hub and do a brembo swap if i was planning on doing so?

Cheers,
Sam

P.S. Sorry if this is a common question i tried searching.

[crazydriver81]

Hi Sam!

cheaper option would be to buy an Eclipse rear wheel bearing (Eclipse AWD 1995-1999) from the States. Other than that I fear you have to take the Mitsi one.

As for the brembo conversion, you will need FL (post 1998) front hub carriers and ABS sensors. The rears from a PFL will be sufficient for the Brembo setup. Just try the searc function harder. ;)

[Zitchu]

If your patient keep an eye out at Pick a Parts. I scored one for $17.

[leepft]

wow 900 bux for a wheel bearing. can you not use a second hand one? if so my leggy will have one

[Davezj]

As stated above why would you not go for the eclipes hubs they are the same as ours.

£100 ish from the USA for 2 front hubs which includes the bearing. It will take a week or two to get shipped over from the states but well worth it. I have just replaced mine and done a brembo upgrade as well.

On the hub carrier front i hope you realise that any Facelift galant or legnum has the same hub carrier not just VR4's

[wintertidenz]

Once you pay for shipping it's about the same price as you pay over here for a Mitsi supplied bearing anyway. And those things aren't light either!

Remember 1 GBP = around $2 NZD.

[Davezj]

With shipping to NZ i make it NZ$289 for a pair of front hubs for the brembo convertion.