e manage blu

[kares_leni]

hi ,do somebody fit this emanage blu ;http://www.nengun.com/trust-greddy/e-manage-blue
on ours car ,I think I can use it as pggy box ecu ?do I need from special cable connectors?is it hard to install it? 10x

[Nutter_John]

Most questions have probably been asked , it is well worth having a look at the clubs search feature as that way saves you having to ask all the time

So you should have a box like the one below on the top of the page , enter the thing you'd like to know about in there and as long as it's longer than 3 chars long it will go away and look through all the posts on the site and pull up ones that fit what you looking for , think of it like google but for vr4s

47879

in the case of what you after now maybe try "emanage blue" or just "emanage" etc

[Beastlee]

Very polite John :)

I fitted my eManage Blue to my own VR4. I would recommend you get one of the inline harnesses to save you damaging the wires going to the car's ECU.
Fitting is not difficult if you have a good pin-out of the ECU and are good at soldering. You will need an ingnition harness and an injection harness if you want full control, other than that the unit comes with everything you need to install. In order to program it you will need the Greddy software unless you also have a Profec E-01. Total install time for someone experienced in soldering will be about 2 hours. Programming should really be done with a rolling road and a way to measure the AFRs.
Hope that helps.

[Nutter_John]

was tempted to find a picture of my rear window at japfest a few years back :D

[Beastlee]

/haz

[kares_leni]

10xboth of you.where do I find ignition harness and an injection harness from ?are they comes with emanage box ,or they are some other kind?which one is with inline harnesses;http://www.ebay.co.uk/sch/i.html?_from=R40&_trksid=p5197.m570.l1313&_nkw=GREDDY+EMANAGE+BLUE+&_sacat=See-All-Categories
10x a lot

[Beastlee]

You only get the basic harness with the e-manage blue. Here's some links to give you an idea what you need :

Ignition Harness - http://www.jtperformance.eu/GREDDY_E-MANAGE_IGNITION_HARNESS_KIT_-_15900902/p455896_4046460.aspx
Injector Harness - http://www.jtperformance.eu/GREDDY_E-MANAGE_INJECTOR_HARNESS_KIT_-_15900902/p455896_4046463.aspx

They also have an e-manage blue - http://www.jtperformance.eu/GREDDY_E-MANAGE_PIGGYBACK_ECU_FUEL_CONTROLLER/p455896_2133658.aspx

Not cheap but worth it if you do the full tuning.

I don't know if Glenn (Wodjno) still has access to this kit.

[Atik]

If you want a Profec E-01 boost controller, then I have one for sale at the moment.
It will enable you to configure and control the Emanage.

[Beastlee]

I have the e-manage Blue and Profec E-01 and they are the perfect combination.

[kares_leni]

last question Beastlee 10x for your info I will get one after when I find out this ;is it needs to do remap on the ECU if I have got emanage blue installed ?10x a lot

[Beastlee]

You do not 'need' a re-map but if you have one of the re-programmable ECUs then I would recommend you make some modifications that cannot be done from the e-manage. If you don't have a reprogrammable ECU it is not a problem.

[kares_leni]

I did not check that dose it my ECU reprogrammable
my car is 97 vr4 legnum do you know is it reprogrammable my ecu?I think my ecu is 7203 but I am not sure

[Beastlee]

Sorry, I can't help there. I am not sure which models and years had which ECUs. Someone else may be able to advise.

[kares_leni]

thanks a lot you help me more than enough.I WILL FIND OUT IT . THANKS AGAIN

[TAR]

a 97 VR4 will have a 7201 ecu (metal case) as standard. Have a look at your ecu, if it has a black plastic case it will be a newer ecu

:happy:

[kares_leni]

what number is plastic black one 72 02?