View Full Version : Front upper wishbone/hub carrier nut size
Erskine_atom
28-08-2011, 09:47 PM
Can anyone tell me what the thread is on the ball joint nut/bolt which connects the upper wishbone to the hub carrier on a pfl vr4?
I stripped the nut on mine being a spastic and over tightening it under tension. /duh
Cheers in advance.
Davezj
28-08-2011, 10:10 PM
The nut is 17mm i think but i am not sure what that equates to in thread size, let me check roymech for details.
I'll be back!
Well i am back!
And roymech says
http://www.roymech.co.uk/Useful_Tables/Screws/Hex_Screws.htm
17mm nut has a M10 1,25 thread.
Well that is what i think.
Nutter_John
28-08-2011, 10:21 PM
sounds about right Dave , fine pitch iirc
Davezj
28-08-2011, 11:19 PM
Yes pitch is what i meant, m10 thread 1.25 pitch.
VR4 is in the details!
If you catch my drift, not wanting offend any religous people out there.
Erskine_atom
29-08-2011, 09:22 AM
Roy sounds like a handy guy to know!
Cheers very much boys!
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.