CplJellyfish
11-12-2004, 11:05 PM
Hi all,
Wonder if you could help out with a little problem I've made for myself...
I was removing the front bumper from my V6-24 (yr 2000) today, so I could replace a broken headlamp washer nozzle, that some kind fool reversed into last week.
Job now done, but I hit a couple of snags:
The nearside fog lamp, which is the Parabola type, is now missing the corner bezel, this is a silvered, non-illuminated bit of plastic, approx 4" long by 2" wide @ the widest part, tapering down to 1". Anyway, it's snapped off by the treatment, :Cry1:. If my image works, it's the bit numbered 3.
Anyone got any idea where I might get another one? Since a new washer nozzle was £40 from Mitsubishi, I'm not too keen on asking them just now...
In the meantime, I've superglued the old bit back on, but I think one stone, and it's gone.
I also managed to snap one of the little bolts used to hold the splash shield (under the offside front wheel arch). Honest, this wasn't my fault, it just sheared off as I was undoing it. I've removed the snapped end from the captured nut, and would like to replace the bolt - again, anyone know a place I can get such things?
Thanks for any advice you can offer...
Wonder if you could help out with a little problem I've made for myself...
I was removing the front bumper from my V6-24 (yr 2000) today, so I could replace a broken headlamp washer nozzle, that some kind fool reversed into last week.
Job now done, but I hit a couple of snags:
The nearside fog lamp, which is the Parabola type, is now missing the corner bezel, this is a silvered, non-illuminated bit of plastic, approx 4" long by 2" wide @ the widest part, tapering down to 1". Anyway, it's snapped off by the treatment, :Cry1:. If my image works, it's the bit numbered 3.
Anyone got any idea where I might get another one? Since a new washer nozzle was £40 from Mitsubishi, I'm not too keen on asking them just now...
In the meantime, I've superglued the old bit back on, but I think one stone, and it's gone.
I also managed to snap one of the little bolts used to hold the splash shield (under the offside front wheel arch). Honest, this wasn't my fault, it just sheared off as I was undoing it. I've removed the snapped end from the captured nut, and would like to replace the bolt - again, anyone know a place I can get such things?
Thanks for any advice you can offer...