View Full Version : Fujitsubo gaskets
lateshow
09-07-2012, 08:58 AM
I just received a fujitsubo Legalis Super R catback but it needs a gasket between middle and the back part. Where can I buy this gasket or should i have one made specially for me?
Wodjno
09-07-2012, 09:04 AM
Can you not just take an imprint of the end of the flange on a piece of paper? Then take it to a local motor factor shop and get a gasket matched to it?
what he said,
its a pretty much standard gasket size, i just picked up generic ones from the local car parts place with the correct hole size the bolt holes were a tiny bit out, but not by more than 1mm no big deal.
lateshow
09-07-2012, 09:26 AM
It seems to need bigger gasket than a 3" one so I should drill it a little bit? Should i make one out of the front gasket (between cat and middle pipe)
id just adjust the 3" one if thats all you can find.
lateshow
15-07-2012, 12:47 PM
Ok, the rear and the middle part DO NOT need a separate gasket between them ! :)
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.