NEED HELP FROM NZ with a performance chip

[leggy4life]

hey im from new zealand and i wanna find out if there is any companys in nz who sells upgraded performance chips for a legnum vr4

[CANDEE]

Hi Marco,

There are no upgraded performance chips for our cars. However remaping is possible, depending on what version of the ecu you have.

[leggy4life]

aw gay haha well what good would remaping me do? and which ecu would i need?

[CANDEE]

Remapping is tuning the car to the mods that you have. You would need a 7202 or 7203 ecu, which usually come in the 98+ cars, but early 98 can be hit and miss.

[leggy4life]

would i be able to eleminate the speed limit and boost cut?

[Subaru ETA]

You can eliminate the speed cut without a remap or aftermarket ECU. Do a search to find out how

[leggy4life]

http://www.galantvr4.org/ubbthreads/showflat.php?Number=469188&page=84&view=&sb=5&o= could this be the right one?

[leggy4life]

also where is the watertemp sensor? i wanna install a aftermarket gauge

[Oggie]

tbh there is no reason to cut the speed limiter in nz, anything 40kph over the posted speed limit is gonna hurt you really bad both fines and dl wise.

[CANDEE]

also where is the watertemp sensor? i wanna install a aftermarket gauge
Just run an aftermarket sensor on the top hose like everyone else. :)

[leggy4life]

yeah i know that but every year in my town there is a quater mile drag and i wanna compete so i dont want the speed to cut out

[leggy4life]

CANDEE that is a good idea haha but how will i adapt the sensor?

[Badger_01]

CANDEE that is a good idea haha but how will i adapt the sensor?

Im sorry but lol

[leggy4life]

im only 17 man help a bro out haha

[wintertidenz]

You won't hit 180kph on the quarter mile without extensive mods, so there's no point in removing the cut unless you race on the track.

You have to buy an aftermarket gauge with a sender, and a water temp adapter that goes in the top hose that the sender bolts into.

[CANDEE]

My fastest drag time with my old leggie was 14.496 @ 96mph... So unless you get over 195kmh you wont have an issue with the speed cut.

[leggy4life]

Thanks guys helps allot and i do have an aftermarket gauge with a sender and all the stuff needed i just wanna know how to do it

[Davezj]

just remeber to fit a chassis ground wire to the hose adaptor that the sensor screws into, othwise the gauage does not work.

as for fitting it, cut the hose, fit the hose adaptor, wire it up, job done.