AVC-R settings of your VR4

[NLduffyNL]

Hi all,

Ive been busy trying to re-adjust my AVC-R but i cannot get it right after many attempts.
Mine keeps lowering its boost after the peak (Get peak 1.2 and drops in lower gears to 0.92)

I was curious what all of your settings are?
If everybody puts in his or her settings on the forum, this might be a good startup for someone that is going to install and setup his AVC-R.

[NLduffyNL]

So what settings did you need to get stable boost

[Gunzu]

I got it stable by using this guide http://teamkansei.forumotion.net/t28-apexi-avcr-tuning-how-to-set-it-up-properly-the-first-time

I have Boost 1.25 and Duty 70-72%. Cant remember the other settings right now.

[NLduffyNL]

I got the 0.8 Bar pretty stable at this moment (only fluctuating about 0.05bar) Didnt had a big test on the 4th and 5h, but its not what i want to drive ;) I cant get my 1.2bar stable. (it keeps getting back to 0.9-1bar without any intercoolerleaks)
Are you willing to put in all your AVCR settings here?
I will put them of 0.8 Bar here so we get something like a database that gives an good indication where you need to be at with a vr4 with AVC-R

[Kenneth]

Have you bypassed the standard boost solenoid? If you haven't the ECU will correct the duty cycle on the standard wastegate solenoid to achieve its target load.

[NLduffyNL]

Yes, got it bypassed, got only the connector in

[Gunzu]

Boost/Duty
Boost 1.20
Duty 70%


F/B speed
1. x
2. 6
3. 4
4. 2
5. 1


Learning
1-x
2,3,4,5 -0


Start Duty
2 and 3 +2%
4 and 5 +1%