jjayokocha
06-07-2013, 04:07 PM
I snapped up a decent Evo fmic the other day for £40, thought I would start a thread for anyone considering doing the same. My car is a Legnum VR-4 98 FL.
Pic 1 - This is almost perfect to get away with using the stock ic hose except one end is 2" id & other 2.5" - Order 90 degree bend with both ends 63mm id
Pic 2 - Evo fmic just hanging on for hose measurements
Pic 3 - Stock FL ic & Evo ( I will have to cut off the original evo brackets and have custom ones done)
Pic 4 - Crash bar refitted with no cutting needed.
Pic 5 - Overhead view of evo fmic sitting in place.
Pic 6 - Closer overhead view of evo fmic in place showing gap between it and chassis & lower bonnet catch bolt/bracket.
Pic 7 - Side view of evo fmic in place
Pic 8 - Hot side FL pipe (can I cut this and just use a 45 degree bend with both ends 63mm id?)
Pic 1 - This is almost perfect to get away with using the stock ic hose except one end is 2" id & other 2.5" - Order 90 degree bend with both ends 63mm id
Pic 2 - Evo fmic just hanging on for hose measurements
Pic 3 - Stock FL ic & Evo ( I will have to cut off the original evo brackets and have custom ones done)
Pic 4 - Crash bar refitted with no cutting needed.
Pic 5 - Overhead view of evo fmic sitting in place.
Pic 6 - Closer overhead view of evo fmic in place showing gap between it and chassis & lower bonnet catch bolt/bracket.
Pic 7 - Side view of evo fmic in place
Pic 8 - Hot side FL pipe (can I cut this and just use a 45 degree bend with both ends 63mm id?)