swinks
06-08-2013, 09:35 AM
There will be massive sale out of various parts coming soon guys. Some serious stuff and some boring, petty etc... :)
All parts will become available from mid September (coming back from holidays to UK). Serious bits may be available later as time let me dismantle them ;)
No pictures yet, but as soon I'll be back I start new threads. Note that this thread is to judge interest only.
Here is provisionally list:
Available in September:
- pair of front Bride seat rails, designated for Galant/Legnum, condition as new (stickers still on), will fit ANY Recaro, Sparco or other sport seat (note: NO stiff bucket seats) - 110 GBP
- stock prefacelift intercooler - 10 GBP
- stock hard pipe Y-shape - 8 GBP
- injectors 560cc low impedance (will require resistor pack for vr4), mileage: 340 miles only - 180 GBP
- fuel rail washer adapters for higher Evo injectors x 4 - 20 GBP
- stock dash clock - 10 GBP
- UTCOMP built in dash clock, OLED version - 65 GBP
- speedo with "Legnum" dual scale facia, a/t version, blue needles - 50 BGP - Exevoowner
- speedo with "Galant" dual scale facia, a/t version, blue needles - 50 GBP - Colin Whiltshire
- Aeromotive 340 lph uprated fuel pump (doesn't need to be hardwired) - 60 GBP - VR457
- sport cat converter 3", only 100cel (!!), with bung for wideband sensor - 170 GBP - Crazydriver81
- stock front upper strut bar - 40 GBP
- used SARD R2D2 blow-off - 70 GBP - TAR
- Coolingmist CMGS methanol full kit (injectors, lines, multitask controler with display, tank, etc) - 200 GBP - TAR
- Apexi S-AFC 2 air/fuel controller - 100 GBP
- KS-ROM ecu - 150 GBP - wookash83, disco-ian
- flashable stock 7202 ecu, will require new flash of either stock maps or modified ones because there is experimental map with 560cc injector scalling flashed in - 100 GBP - Darren1976
- set of new genuine Mitsubishi valve stem seals (12 intake and 12 exhaust) - 50 GBP
- front bi-xenon headlights, including wiring harness and HID ballast - 250 GBP
- Martin71
Bits available later (October):
- blue flock interior, main dashboard, centre console/arm rest, 4 door cards, B-pillars covers - 200 GBP
- 2x front Recaro seats, adopted from Vectra GSI, provisionally fitted brackets to rails to fit Galant floor pan, driver seat has little tear in side bolster area - 50 GBP
- Momo stering wheel - 50 GBP
- Apexi air filter with MAF adapters - 50 GBP
- bigger V6 throttle body with TCL, fitting will require adjusting following: SAS, APS and TPS, also some machine out of pfl intake plenum inlet is required - 80 GBP - Davezj
- air conn radiator - 20 GBP - 2700gavin
- air conn compressor/pump - 50 GBP
- PAS pfl pump - 30 GBP
- very low mileage alternator 120A - 100 GBP
- engine and gearbox polybush mounts, set of 4, manual version only - 100 GBP - Colin Whitshire
- rear hubs (pair) with fitted polybushes - 60 GBP - Ramjam
- front lower suspension arms, Mitsubishi Asia market coded MBxxxxx, 1.5 yr old, set of 4 - 100 GBP - adaxo
- pair of rear upper arms U-shaped with fitted polybushes - 40 GBP - Ramjam
- Cusco anti-roll bars, front and rear - 150 GBP - Crazydriver81, TAR
- set of D2 coilovers - 340 GBP
- front facelift wheell hubs, pair, (good for Brembo conversion) - 120 GBP
- Brembo brake calipers, front + rear - 300 GBP - Echo Whiskey
- 4x Enkei 17" Evo wheels, tyre size 235/45, some curbing to outer rimms - 200 GBP - Echo Whiskey
- stainless de-cat 3" pipe with lambda sensor bung - 30 GBP
- full stainless Toyo cat-back 3" system - 190 GBP
- RPW stainless 3" downpipe, front flexi tired but not blowing yet, replacement flexi will be provided - 140 GBP - Colin Whiltshire
- manual VR4 gearbox converstion kit (gearbox, clutch kit, master + slave cylinders, linkage, pedals etc) - 600 GBP - wookash83
- stock turbochargers (front + rear) - 120 GBP - Gingerfish
- engine, approx. 54k miles on the clock - 370 GBP (without ancilliares), 460 GBP with ancilliares
- agressive profile 262 regrinded camshafts (details in Adama Findlay threads), provided with full set of Brian Crower BC1100 springs - 580 GBP - Colin Whiltshire
- genuine carbon fibre bonnet with scoop for side cold air intake - 200 GBP - Gingerfish
- light bonnet hydraulic lifters - 40 GBP - Exevoowner
- rear lights, pair, facelift, saloon - 60 GBP
- saloon boot bonnet with stock wing, black - 40 GBP
- ayc pump - 90 GBP - Garreth001
- stock ayc rear differ - 100 GBP - Fassi1
- Evo 8 S-AYC differ - 300 GBP
- alluminium thick 50mm core radiator adapted from Evo 8, plus fans and shroud, and hoses (lower bracekts needs to relocate) - 140 GBP - Gingerfish
- large FMIC intercooler, 600x300x76 - 75 GBP - wookash83, GalantOnly
- set of 24 genuine Mitsubishi hydraulic lifters, mileage ONLY 760 miles, as new! - 200 GBP
- front facelift bumper, black - 80 GBP - WillVR4
- front facelift grille, requires refurb (paint is "bubbling") - 30 GBP
- front wheel arch liners, pair, no damage - 20 GBP
- sideskirts, black, facelift, pair - 40 GBP - 2700Gavin
- rear spats, black, pair - 30 GBP
- genuine Galant brushed aluminium door sills - 75 GBP - Anderz
- Galant rear bumper, black, with fitted in fog lights, paint needs attention - 30 GBP
- aftermarket black rubber mudguards/flaps - 15 GBP
- custom hard pipe kit - 100 GBP
And more to follow... just ask via PM.
All provisionally prices exclude shipping!
All parts will become available from mid September (coming back from holidays to UK). Serious bits may be available later as time let me dismantle them ;)
No pictures yet, but as soon I'll be back I start new threads. Note that this thread is to judge interest only.
Here is provisionally list:
Available in September:
- pair of front Bride seat rails, designated for Galant/Legnum, condition as new (stickers still on), will fit ANY Recaro, Sparco or other sport seat (note: NO stiff bucket seats) - 110 GBP
- stock prefacelift intercooler - 10 GBP
- stock hard pipe Y-shape - 8 GBP
- injectors 560cc low impedance (will require resistor pack for vr4), mileage: 340 miles only - 180 GBP
- fuel rail washer adapters for higher Evo injectors x 4 - 20 GBP
- stock dash clock - 10 GBP
- UTCOMP built in dash clock, OLED version - 65 GBP
- speedo with "Legnum" dual scale facia, a/t version, blue needles - 50 BGP - Exevoowner
- speedo with "Galant" dual scale facia, a/t version, blue needles - 50 GBP - Colin Whiltshire
- Aeromotive 340 lph uprated fuel pump (doesn't need to be hardwired) - 60 GBP - VR457
- sport cat converter 3", only 100cel (!!), with bung for wideband sensor - 170 GBP - Crazydriver81
- stock front upper strut bar - 40 GBP
- used SARD R2D2 blow-off - 70 GBP - TAR
- Coolingmist CMGS methanol full kit (injectors, lines, multitask controler with display, tank, etc) - 200 GBP - TAR
- Apexi S-AFC 2 air/fuel controller - 100 GBP
- KS-ROM ecu - 150 GBP - wookash83, disco-ian
- flashable stock 7202 ecu, will require new flash of either stock maps or modified ones because there is experimental map with 560cc injector scalling flashed in - 100 GBP - Darren1976
- set of new genuine Mitsubishi valve stem seals (12 intake and 12 exhaust) - 50 GBP
- front bi-xenon headlights, including wiring harness and HID ballast - 250 GBP
- Martin71
Bits available later (October):
- blue flock interior, main dashboard, centre console/arm rest, 4 door cards, B-pillars covers - 200 GBP
- 2x front Recaro seats, adopted from Vectra GSI, provisionally fitted brackets to rails to fit Galant floor pan, driver seat has little tear in side bolster area - 50 GBP
- Momo stering wheel - 50 GBP
- Apexi air filter with MAF adapters - 50 GBP
- bigger V6 throttle body with TCL, fitting will require adjusting following: SAS, APS and TPS, also some machine out of pfl intake plenum inlet is required - 80 GBP - Davezj
- air conn radiator - 20 GBP - 2700gavin
- air conn compressor/pump - 50 GBP
- PAS pfl pump - 30 GBP
- very low mileage alternator 120A - 100 GBP
- engine and gearbox polybush mounts, set of 4, manual version only - 100 GBP - Colin Whitshire
- rear hubs (pair) with fitted polybushes - 60 GBP - Ramjam
- front lower suspension arms, Mitsubishi Asia market coded MBxxxxx, 1.5 yr old, set of 4 - 100 GBP - adaxo
- pair of rear upper arms U-shaped with fitted polybushes - 40 GBP - Ramjam
- Cusco anti-roll bars, front and rear - 150 GBP - Crazydriver81, TAR
- set of D2 coilovers - 340 GBP
- front facelift wheell hubs, pair, (good for Brembo conversion) - 120 GBP
- Brembo brake calipers, front + rear - 300 GBP - Echo Whiskey
- 4x Enkei 17" Evo wheels, tyre size 235/45, some curbing to outer rimms - 200 GBP - Echo Whiskey
- stainless de-cat 3" pipe with lambda sensor bung - 30 GBP
- full stainless Toyo cat-back 3" system - 190 GBP
- RPW stainless 3" downpipe, front flexi tired but not blowing yet, replacement flexi will be provided - 140 GBP - Colin Whiltshire
- manual VR4 gearbox converstion kit (gearbox, clutch kit, master + slave cylinders, linkage, pedals etc) - 600 GBP - wookash83
- stock turbochargers (front + rear) - 120 GBP - Gingerfish
- engine, approx. 54k miles on the clock - 370 GBP (without ancilliares), 460 GBP with ancilliares
- agressive profile 262 regrinded camshafts (details in Adama Findlay threads), provided with full set of Brian Crower BC1100 springs - 580 GBP - Colin Whiltshire
- genuine carbon fibre bonnet with scoop for side cold air intake - 200 GBP - Gingerfish
- light bonnet hydraulic lifters - 40 GBP - Exevoowner
- rear lights, pair, facelift, saloon - 60 GBP
- saloon boot bonnet with stock wing, black - 40 GBP
- ayc pump - 90 GBP - Garreth001
- stock ayc rear differ - 100 GBP - Fassi1
- Evo 8 S-AYC differ - 300 GBP
- alluminium thick 50mm core radiator adapted from Evo 8, plus fans and shroud, and hoses (lower bracekts needs to relocate) - 140 GBP - Gingerfish
- large FMIC intercooler, 600x300x76 - 75 GBP - wookash83, GalantOnly
- set of 24 genuine Mitsubishi hydraulic lifters, mileage ONLY 760 miles, as new! - 200 GBP
- front facelift bumper, black - 80 GBP - WillVR4
- front facelift grille, requires refurb (paint is "bubbling") - 30 GBP
- front wheel arch liners, pair, no damage - 20 GBP
- sideskirts, black, facelift, pair - 40 GBP - 2700Gavin
- rear spats, black, pair - 30 GBP
- genuine Galant brushed aluminium door sills - 75 GBP - Anderz
- Galant rear bumper, black, with fitted in fog lights, paint needs attention - 30 GBP
- aftermarket black rubber mudguards/flaps - 15 GBP
- custom hard pipe kit - 100 GBP
And more to follow... just ask via PM.
All provisionally prices exclude shipping!