View Full Version : BOUGHT Tow bar for Legnum vr4 with ayc
golden
30-08-2013, 08:27 PM
Now ive sorted all the niggles out after buying my vr4 (including a whole new engine) i can start to put it to its intended use, trailing my track car!
so im after a towbar OR if anyone has photos of one fitted from underneath .
ive got plenty of steel lying about and wouldn't mind ago at making one with a universal ball joint.
cheers :)
sonicsoundzdj
31-08-2013, 02:07 PM
Iv got one off a v6 estate but not sureif there the same
Hi golden, I have fitted a tow bar to my leggie. You need a towbar to fit a normal galant estate, ours was a witter, CL73,you just need to cut out a couple of nicks to accommodate the ayc captive nuts on the chassis rail. There was a picture/post showing you in the club. Ill try have a look for it. Any questions just ask.
Marc
elnevio
31-08-2013, 02:15 PM
They are the same. The only amendment you need to make is to cut the two notches out of one of the chassis braces to accommodate the two captive AYC nuts.
Hi golden,
This is the link I used:
http://www.clubvr4.com/forum/showthread.php?27542-Towbar-Advice-for-VR4-Legnum-Estate&highlight=Tow+bar
Title is:
Towbar advice for vr4 legnum estate by Shrew.
Hope this helps
marc
golden
31-08-2013, 03:32 PM
Iv got one off a v6 estate but not sure if there the same
PM'd
thanks for the info guys, im not a paid member so i cannot see that thread but a few notches sounds easy enough :)
golden
01-09-2013, 07:28 PM
got one sorted now thanks for all the input :)
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.