amp power cable route

[zanzibar]

Installing a amp next week,does anyone know the best way to get a 4 guage wire from front to back without drilling into the firewall.

[jaspa]

There's a hole into the wing from the standard battery tray, I've used this but haven't found an adequate route back inside the car, I've gone in through the grommet with the door loom but haven't revisited the project in a while to find somewhere better.

HTH a bit

Stuart

[zanzibar]

Do i have to remove the wing to access the hole

[c0xxy]

Can be done with out removing the wing, bit frustrating tho taking the indicator out allows you to see what your doing a bit better.

Ive relocated my battery and took the cable through the bulk head with the ecu wiring harness.

Sent from my GT-I9505 using Tapatalk 2

[wintertidenz]

Just a note - when you run the cable through there make a loop in it that sits lower than the grommet so water doesn't track down the cable into the cabin.

I learned this the hard way.

[Wobble]

if you own a auto then a very easy way is through the hole that the clutch would have used .

[c0xxy]

Or fill it full of silicone :-D

Sent from my GT-I9505 using Tapatalk 2

[CANDEE]

You can use the grommet by the ayc pump in the engine bay and the high one by it through the a pilar.

[SEAN-NZ]

You can use the grommet by the ayc pump in the engine bay and the high one by it through the a pilar.

you can do what witth the ayc pump in the engine bar? and the high one through a pillar? are you drunk? haha

[galantnight]

Go through the passenger footwell there is a big grommet there, run cable down the left hand side of car and under back seat.
I do have some photos i will post if you get stuck or are not sure ok.

[zanzibar]

thanks for the the help gents much appreciated.

[wintertidenz]

you can do what witth the ayc pump in the engine bar? and the high one through a pillar? are you drunk? haha

I think he meant ABS pump.

[CANDEE]

Yeah ABS, have damn AYC on the mind with my current project on the car... lol

[zanzibar]

got the cable through the passenger wing pretty easy apart from taking the wheel arch cover off, some awkward angled bolts but got there in the end. thanks for all the advice peeps :thumbsup:

[galantnight]

got the cable through the passenger wing pretty easy apart from taking the wheel arch cover off, some awkward angled bolts but got there in the end. thanks for all the advice peeps :thumbsup:

Thats good just make sure it cant rub against anything and earth out.

[wintertidenz]

I'd suggest you make sure it's cable tied to the main loom that runs through there. I've had the cable drop down in my last install so I had to go and take ALL that stuff off again to fix it up.

[zanzibar]

I'd suggest you make sure it's cable tied to the main loom that runs through there. I've had the cable drop down in my last install so I had to go and take ALL that stuff off again to fix it up.

all cable tied up

[djhi]

any chance u took pics?

[djhi]

7187971880 sorry there bad but hope this helps sumone like this page did me cheers guys!

[zanzibar]

pics are always good mate... glad you got there in the end.