View Full Version : Help!! Clutch pedal has completey sunk to the floor and does not spring back!!!!
GalantV6
07-10-2013, 05:01 PM
The clutch pedal on my 2000 galant V6-24 Sport has completey sunk to the floor and does not come back up!
What has happend?
Cheers
MarkSanne
07-10-2013, 05:18 PM
Clutch lever cylinder might be RIP. Refurb-sets can be bought from the stealer or camskill (quite inexpensive btw). These are good serviceable. Check your fluid-level first, then determine where the fluid is leaking. Just follow the hard pipe from the fluid reservoir.
Hi there,
Mine did this after I changed my engine and it just needed bleeding through but I did have it stored upside down in the engine bay.
Marc
exevoowner
07-10-2013, 06:29 PM
could be flexi hose gone or bearing ?
GalantV6
07-10-2013, 07:20 PM
Clutch lever cylinder might be RIP. Refurb-sets can be bought from the stealer or camskill (quite inexpensive btw). These are good serviceable. Check your fluid-level first, then determine where the fluid is leaking. Just follow the hard pipe from the fluid reservoir.
Hi When you say "Clutch lever cylinder" is that a "clutch master cylinder"?
Cheers
Nick Mann
07-10-2013, 10:22 PM
It could be the master or the slave or the pipework between. The clutch is hydraulic, so if you lose the hydraulic fluid, there is nothing to push the pedal back up. Look for the leak!
When this happened to me it was my clutch thrust bearing.
Nick Mann
08-10-2013, 05:49 AM
I wondered that, Ryan, but this is a fwd v6 I think. I was under the impression that they are push type?
Oh, sorry Nick - I've no idea then! :)
Nick Mann
08-10-2013, 04:59 PM
I could be wrong. It's something I have heard, not something I have seen.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.