crazydriver81
18-01-2014, 03:09 PM
Selling the hard pipe kit I recently bought from Peter Thomson. These are the hard pipes from a Group Buy a couple of months ago ( http://www.clubvr4.com/forum/showthread.php?46663-UK-Group-Buy-Hard-Pipe-Kit&highlight=hard+pipe+kit )
I changed my mind because I don't like the look of the brushed stainless steel in my engine bay and I'll go for another solution replacing the plastic ellbow too. I trial fitted the rear 90 degree pipe only before decided to part with it and fitment was OK (not perfect but lined up well).
What is in the set:
- stainless steel hard pipes in brushed finish, replacing all three flex pipes
- unbranded 4-layer silicon joiners in black (2x 51mm ID / 3x 63mm ID / 1x reducer 63mm/70mm ID)
- stainless steel Mikalor clamps (only half of all needed - but at least a start :) )
I am looking for 140 GBP shipped to UK/mainland Europe but will consider reasonable offers on it. Can also ship worldwide on buyers expense.
I changed my mind because I don't like the look of the brushed stainless steel in my engine bay and I'll go for another solution replacing the plastic ellbow too. I trial fitted the rear 90 degree pipe only before decided to part with it and fitment was OK (not perfect but lined up well).
What is in the set:
- stainless steel hard pipes in brushed finish, replacing all three flex pipes
- unbranded 4-layer silicon joiners in black (2x 51mm ID / 3x 63mm ID / 1x reducer 63mm/70mm ID)
- stainless steel Mikalor clamps (only half of all needed - but at least a start :) )
I am looking for 140 GBP shipped to UK/mainland Europe but will consider reasonable offers on it. Can also ship worldwide on buyers expense.