View Full Version : PLX DM-6 Install question
Z-Kev
13-02-2014, 08:21 PM
For those of you who are using one of these, when you connected it up did you fit the resistors on the heater circuit wires or not, as I have seen a post on here saying just leave them disconnected?
Nick Mann
13-02-2014, 11:18 PM
Do you mean the PLX AFR? Connected to a DM-6?
There is no need to stick a resistor on the stock lambda sensor heater circuit - there is no check engine light if you just remove it. I am using PLX stuff and the AFR emulates narrowband to the ECU. Stock sensor removed and only the ecu feed from the stock connector is now connected to anything.
Z-Kev
14-02-2014, 06:17 AM
Thx Nick, exactly what I wanted to know.
Do you mean the PLX AFR? Connected to a DM-6?
There is no need to stick a resistor on the stock lambda sensor heater circuit - there is no check engine light if you just remove it. I am using PLX stuff and the AFR emulates narrowband to the ECU. Stock sensor removed and only the ecu feed from the stock connector is now connected to anything.
Powered by vBulletin® Version 4.2.0 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.