driveshafts

[Scanny]

O/S/F driveshaft to fit a PFL manual VR4. this one is now urgent to get the car driveable again

N/S/F driveshaft for a FL auto V6 n/a. might have both sides just in case. i know a FL manual driveshaft will fit the offside on the V6

[AKKO]

What condition are you OK with, happy to refurb them CV joints etc?

[sonicsoundzdj]

Iv got both sides off a n/a v6 if there any help?

[Scanny]

Iv got both sides off a n/a v6 if there any help?

i know i can use auto or manual driveshafts for the offside since i have one on now from my old manual V6 but they are both FL. i dont know if the nearside will fit though. how much do you want for them?

[Scanny]

What condition are you OK with, happy to refurb them CV joints etc?

i found a pair from a manual VR4 on ebay. i am going to grab them but thanks anyway

[sonicsoundzdj]

... how much do you want for them?

Not sure what the going rate is to be honest. £50 the pair?
sounds like youve got some now anyway

[Scanny]

i have found a pair for the legnum but i want spares for the V6. the offside is from my old manual V6 which was sat in my back garden waiting for the weigh in at a scrapyard. the driveshaft went on the new V6 and that couldnt be refurbished. luckily the manual one fitted but i dont know how long it will last. a couple of hours of labour is a lot cheaper than having to hire a car while i find a replacement if the other driveshaft goes. i would prefer to have the spares sitting there just in case

[Scanny]

still looking for all of these parts

[Scanny]

VR4 driveshaft no longer required

[Scanny]

bump

the driveshaft for the VR4 is the wrong one (hopefully a manual nearside instead of offside) and is approximately 10mm too long so i still need an offside driveshaft for a PFL
still looking for offside front driveshafts for a FL auto n/a V6

edit: i found a nearside front driveshaft from a 1999 auto V6