billybobboot
01-03-2015, 05:26 PM
as above, took it all apart and found that there was a little dent on it took the clutch bearing retainer (guide plate
) off and when the gearbox berings went and the box was rebuilt they didnt replace this even though it was dammaged a little, its not bad but for the sake of it i really cant be bothered to take the gearbox off again so replaing it.
the only ones i can find dont have 4 even spaced bolt holes there slightly off set mine are all spaced even, its backly a roud plate with a step in then a nic sleve and the 4 bolt holes are 4 tabs evenly spaced to hold it on. any ideas i could just use the old one but its marked so dont really want to.
) off and when the gearbox berings went and the box was rebuilt they didnt replace this even though it was dammaged a little, its not bad but for the sake of it i really cant be bothered to take the gearbox off again so replaing it.
the only ones i can find dont have 4 even spaced bolt holes there slightly off set mine are all spaced even, its backly a roud plate with a step in then a nic sleve and the 4 bolt holes are 4 tabs evenly spaced to hold it on. any ideas i could just use the old one but its marked so dont really want to.